- 300 - 6a05 thru 6a100 6.0 amps. silicon rectifiers voltage range 50 to 1000 volts current 6.0amperes features low forward voltage drop high current capability high reliability high surge current capability mechanical data cases: molded plastic epoxy: ul 94v-o rate flame retardant lead: axial leads, solderable per mil- lead: std-202, method 208 guaranteed polarity: color band denotes cathode end high temperature soldering guaranteed: 250c/10 seconds/.375?,(9.5mm) lead lengths at 5 lbs., (2.3kg) tension weight: 1.65 grams r-6 dimensions in inches and (millimeters) maximum ratings and electrical characteristics rating at 25c ambient temperature unless otherwise specified. single phase, half wave, 60 hz, resistive or inductive load. for capacitive load, derate current by 20% type number 6a05 6a10 6a20 6a40 6A60 6a80 6a100 units maximum recurrent peak reverse voltage 50 100 200 400 600 800 1000 v maximum rms voltage 35 70 140 280 420 560 700 v maximum dc blocking voltage 50 100 200 400 600 800 1000 v maximum average forward rectified current .375 (9.5mm) lead length @t a = 60c 6.0 a peak forward surge current, 8.3 ms single half sine-wave superimposed on rated load (jedec method ) 250 a maximum instantaneous forward voltage @ 6.0a 0.95 v maximum dc reverse current @ t a =25c at rated dc blocking voltage @ t a =100c 10 400 ua ua maximum full load reverse current, full cycle average .375?(9.5mm) lead length @t a =75c 50 ua typical junction capacitance ( note 1 ) 100 pf typical thermal resistance r ja ( note 2 ) 10 c/w operating temperature range t j -65 to +125 c storage temperature range t stg -65 to +150 c notes: 1. measured at 1 mhz and applied reverse voltage of 4.0 v d.c. notes: 2. thermal resistance from junction to ambient .375? (9.5mm) lead length.
- 301 - ratings and characteristic curves (6a05 thru 6a100) forward voltage. (v) fig.2- typical forward characteristics instantaneous for ward current . (a) 1.8 1.6 .6 2.0 .8 1.0 1.2 1.4 100 1000 30 3.0 10 1.0 .1 tj=25 c pulse width=300 s 1% duty cycle o fig.3- typical reverse characteristics instantaneous reverse current .( a) 0 20 40 60 80 100 120 .01 .1 10 100 1.0 percent of rated peak reverse voltage. (%) tj=25 c 0 tj=100 c 0 fig.4- maximum non-repetitive forward surge current peak for ward surge current . (a) number of cycles at 60hz fig.5- typical junction capacitance junction cap acitance.(pf) 100 50 10 1 100 200 500 1000 50 10 reverse voltage. (v) tj=25 c 0 fig.1- maximum output current vs ambient temperature average for ward current amperes 20 0 40 60 80 100 120 140 180 160 2 3 1 4 6 5 ambient temperature. ( c) o single phasehalf wave 60hz resistive of inductive load standard pc board mounting pc board ground plane 1" x 1" copper surface area pc board recommanded pc board mounting 100 1 5 10 50 0 150 100 50 200 250 300 tj=25 c o
|